Remote dog training collar vocational training equipment

Remote dog training collar

100 Level Shock, Vibration Remote Dog Training Collar

LCD display four functions: Static Shock/Vibration/Beep/Light

300 meters range

100 levels of vibration and 100 levels of static shock

Can be used for 1 or 2 pets training system with extra collar

This remote dog training collar is the most effective and safest tool for training pets. By using of it, pets can understand the intention of its owner. The collar is soft and light, no harm to the pets, vibration induction power switch for energy saving .Rechargeable for both devices. Following the correct operational instructions, you can effectively train your pets in a short while.

Features:

1. Designed in USA, Used for mild-mannered to stubborn pets.

2. Rechargeable remote transmitter and receiver collar for 1 or 2 pets.

3. Over 3,000 different identity codes to prevent conflicts with other e-collars.

4. Big LCD display all functions: Static shock/Vibration/Beep/Light.

5. 100 levels can be altered for vibration and static shock.

6. In light mode, you can easily find which dog you are training.

7. Vibration induction power switch in the collar receiver.

8. Self sleep and memory function for the remote transmitter.

9. LED flashlight helps you find your pet easily at night or can be another training aid.

 How to use the transmitter:

1. To turn on/off the Transmitter, Press the mode button on the Transmitter;

2. By pressing the Mode button to change different modes ----LCD display will show the corresponding function .

3. Press up and down buttons on right hand side to set level---The level must be more than 000

4. Choose the different channels to control different receivers.

5. The Transmitter will go into STANDBY MODE if not operated for 20 seconds and will TURN OFF if not operated for 2 minutes.

6.1n STANDBY MODE, press any button (except LED light button) to wake it up.

Remark: The transmitter and the collar receiver already matched well, if you want to reset, please following below instruction:

1. Turn on the Transmitter and choose 1or 2 channels to encode.

2. Open the Reset rubber of collar receiver.

3. Use a toothpick or similar tool to insert into the Reset HOLE

4. Press the LAUNCH button( Y ) on the Transmitter immediately while you are hearing a beep from the collar.

5. The collar will beep again if encode successfully. If not, please press the reset as long as no light indicator show, then repeat step 1~4.